If they look really corroded, you need to clean the battery posts and cable connectors or replace the cables and try to start the engine. Very often this could be caused by a low battery or poor connection between the battery and starter.Д¬heck the battery and the terminal cable connections. If you turn the key to the вЂњStartвЂќ position, but the engine wonвЂ™t crank all you hear is a single click or repeated clicking coming from the engine compartment. The 2013 Ford Edge car makes a clicking noise but wonвЂ™t start:

Replace starter solenoid, starter contacts, starter assembly or repair starter circuit as required. The solenoid attached to the top of the starter can fail, as well as the components inside. Most commonly this could be caused by a low/dead battery or there is no connection between the battery and starter.Д¬heck the battery and the terminal cable connections. If nothing happens when you turn the ignition key to the вЂњStartвЂќ position, it means that the starter motor doesnвЂ™t turn over the engine. 2013 Ford Edge No Start, No Sound, No Crank when you turn the key in the ignition: In this case, try turning the steering wheel left and right while gently jiggling the ignition key вЂ“ this might help to release the steering lock. If the key wonвЂ™t turn in the ignition, it could be for a couple of reasons: Often this happens when the steering is locked by the ignition lock with the front wheels turned aside or when one of the front wheels is pushed against something. 2013 Ford Edge the key wonвЂ™t turn in the ignition If the battery is completely dead, jump starting might help. Check if the battery terminals look tight. If no lights coming on in the dashboard and no other electrical consumers work, the battery could be completely dead or there is no connection between the battery and the vehicle electrical system. No lights on the 2013 Ford Edge dashboard Just out of curiosity, are you still running your original battery? Have you had any signs of emminant failure?There are a number of issues that can go wrong with starting system and make your 2013 Ford Edge car wonвЂ™t start or hard time to start вЂ“ This article guides you through some of the facts behind the starting system, and the components that may be to blame, and tells you what action you can take to try to remedy each situation. ThatвЂ™s what causes the engine to stall in extreme conditions. However, it is not prepared to see liquid gas coming into the intake. The PCM expects to see gas vapors entering the intake manifold and it is prepared to adjust air/fuel mixtures to compensate. ItвЂ™s at that point that all the liquid gas in the line gets sucked into the charcoal canister. Then, when the engine meets certain temperature and driving criteria, the PCM issues a purge command to the charcoal canister to remove the stored gas vapors. After refueling the PCM on the vehicle detects a change in fuel level. When the valve fails, liquid gas can enter the line and fill the charcoal canister. The valve is designed to prevent liquid fuel from entering the charcoal canister/emissions system. The problem may be the vapor/liquid separator valve.

Ford edge stalls starts right backup